Vertical Panel Saw purchase; 13 things to look for before pulling the trigger. in Atlanta Georgia

13. Welded components; When you weld metal, the heating often distorts the material and can have unseen faults that will affect the structural integrity of the metal. That is why buildings and bridges are riveted. Brand B welds these parts because it is cheaper and easier to manufacture that way. Brand A does not because they make a component design so you can replace parts like a fence or a guide tube. (These are the two most replaced parts. At a home center store you will see big bollards in front of the panel saw because they have to replace it for every bump it gets.) With Brand A, component design you can replace a guide tube in 2 minutes and a fence in 4. With Brand B, you are replacing the entire panel saw not just the part. Besides the ease of replacement, you don't damage or deform the parts by welding them. On their fence of Brand B, each material roller needs to aligned individually to make sure you are getting a square cut because the fence plate is welded to the frame. Brand B has 13 adjusting points to square their panel saw. That is why the home center stores will not guarantee an accurate cut.

Learn More

Saw Trax Manufacturing, Inc. | Atlanta

Vertical Panel Saw purchase; 13 things to look for before pulling the trigger. in Atlanta GA

10. Dust collection is more than just a convenience today. With the many different material like cement board and the chemicals in some substrates, particulate in the air becomes an important concern. Brand A has a dust brush surrounding the saw blade under the insert with a 2.5" hose attached to the dust bonnet for extraction of the suspended particulate. Brand B uses a vinyl tube that has to be constantly adjusted up or down to rest on the different thicknesses of material cut. If you forget to adjust it one time, the material pushes the tube into the saw blade and you no longer have dust collection. Learn More

Saw Trax Manufacturing, Inc. | Atlanta

Vertical Panel Saw purchase; 13 things to look for before pulling the trigger. in Atlanta GA

10. Dust collection is more than just a convenience today. With the many different material like cement board and the chemicals in some substrates, particulate in the air becomes an important concern. Brand A has a dust brush surrounding the saw blade under the insert with a 2.5" hose attached to the dust bonnet for extraction of the suspended particulate. Brand B uses a vinyl tube that has to be constantly adjusted up or down to rest on the different thicknesses of material cut. If you forget to adjust it one time, the material pushes the tube into the saw blade and you no longer have dust collection. Learn More

Learn More

5 . Component based system is being able to replace key components should they get damaged. If you look at a Home Depot store, you will see big Bollards near the panel saw. These are here because if the material fence or guide tube is damaged, they will need to replace the entire saw since these components are welded. Brand A has these two key components bolted onto the frame so they can be replaced easily if they become damaged. Brand B has these components welded on so they can't be replaced and a new machine needs to be ordered.

Saw Trax Manufacturing, Inc. Vertical Panel Saws Atlanta

,

BEST Vertical Panel Saw purchase; 13 things to look for before pulling the trigger. in Atlanta GA